Installing Lineage on Nintendo Switch 8.1.0

1 Просмотры
Издатель
thanks for watching everyone and supporting this channel. i am sorry about the audio issues and the lag. lost some footage and editing real late. im barely seeing the mistakes i made. enjoy the video.

installation instructions
Pick the image that corresponds to the size of your SD card. You can use an image that is smaller than your card. You’ll end up with the remaining space unused on your card.
Write the image to your SD card with balenaEtcher Do not extract the image, Etcher can handle the compressed image just fine! WARNING: This will overwrite any contents on your card! The progress bar/percentage might go haywire in Etcher, but you can ignore that. The flashing will still work and Etcher will let you know when it’s done. It can take up to an hour depending on your SD card’s speed. Also make sure not to format any of the partitions when Windows prompts you to after flashing.
Download GApps for Android from OpenGApps, use ARM64. Put the file on the first partition of your new SD card
If desired download the "Shield-ifier" zip and place it also on the SD card. This will make your Switch identify as Nvidia Shield TV and install the Nvidia app.
Load hekate and boot to TWRP by holding VOL+ when you select the Android config.
Make sure to mount /system first in TWRP. Flash GApps zip, optionally flash other zips. Also after installing GApps wipe cache/dalvik as offered by TWRP. Video that shows how to access and flash zips in TWRP:
Reboot to hekate and boot into Android
Complete the inital setup. For the Nvidia app to work make sure to update it from Play Store!

if you would like to donate and support this channel follow this link:



link to website:


hekate zip file:



BlenaEtcher Flash software:



open gapps :
Категория
Сеть и интернет
Комментариев нет.